Foaming

5L PUMP UP FOAM INJECTOR 44PSI

Code VOL/TERMIFOAM

CategoriesFoaming

Product details

Overview

The Termifoam 5 L Pump Up Foam Injector is a hand-pressurised foam applicator. Pest Management Professionals use it to inject foam-based termiticide into wall cavities.

Liquids sprayed into a wall cavity tend to run straight down. Foam fills the space and stays where it is put, so it suits areas you can't reach with a standard spray. The unit is pressurised with the hand pump, so you don't need an air line, compressor or power lead.

The tank holds 5 L, so you can treat more cavities before stopping to refill. It works at a maximum of 44 PSI (about 3 bar) and has a safety pressure valve.

Product Highlights

  • EPDM seal: EPDM is a synthetic rubber chosen for its resistance to many water-based chemical mixes. A seal that holds up means fewer leaks and longer service life.
  • Safety pressure valve: the valve releases pressure above the unit's working limit, which protects both you and the tank. The maximum working pressure is 44 PSI (about 3 bar).
  • Anti-glide base: keeps the tank steady while you pump it up or set it down between injection points, so it is less likely to tip or slide on smooth floors.

Where to use

Made for applying foam-based termiticide into wall cavities. Always check that the termiticide you are using is registered for the situation you are treating, and follow its label.

Application

  • Mix and fill the termiticide as its label directs. Do not overfill the tank.
  • Pressurise the tank with the built-in hand pump. Do not go above the 44 PSI (about 3 bar) maximum.
  • Inject the foam into the wall cavity through the access point.
  • Use the safety pressure valve to release pressure before you open the tank to refill, clean or store it.
  • Application rates, foam volumes and treatment patterns are set by the termiticide label, not by the applicator.

Safety

This is application equipment, so it carries no poisons schedule. The PPE and poisons schedule that apply are the ones on the termiticide you put in the tank. Wear the PPE that label requires.

  • Do not go above the 44 PSI (about 3 bar) maximum working pressure.
  • Release pressure with the safety valve before opening the tank.

FAQ

  • Which products can I use in it? It is made for foam-based termiticides applied into wall cavities. Before you use a product, check that its label allows foam application in that situation. The seal is EPDM, which is generally suited to water-based mixes. If you plan to use an oil- or solvent-based product, check that it is compatible with EPDM first.
  • Do I need a compressor or power? No. You pressurise the tank with the hand pump, up to 44 PSI (about 3 bar). That makes it practical for jobs inside occupied homes or anywhere without power.
  • Why choose the 5 L unit over a smaller foamer? 1.2 L Termifoam injectors are usually sold for small, spot treatments such as window frames and skirting boards. The 5 L tank lets you treat more cavities between refills on bigger jobs. The trade-off is a heavier unit to carry when full.

Pack Size

Sold as a single 5 L pump-up foam injector with a maximum working pressure of 44 PSI.

  • How to order: Garrards product code VOL/TERMIFOAM