Foaming

PORTABLE AEROSOL SYSTEM / VERSAFOAMER COMBO UNIT 220V 18″ EXTENSION STD

Code BG/16600218

CategoriesFoamingFoaming

Product details

Overview

The B&G Portable Aerosol System (PAS) / Versafoamer Combo Unit gives Pest Management Professionals two application tools in one kit. It pairs a ULV portable aerosol sprayer with a Versafoamer 4000 power foamer. Both run from a single case and compressor.

The aerosol side reaches deep into wall voids and also handles crack and crevice work and localised fogging. Liquid pressure can be adjusted to produce anything from a heavy mist to a ULV fog. It can also apply liquid only for crack and crevice work, or air only for flushing pests out.

The foamer side mixes chemical, water and a foaming agent and applies the foam through a hose and tip. This makes it suitable for commercial kitchens and for foaming wall voids during termite work. To switch between functions, you swap the tank and valve. You don't need to buy and carry two separate machines.

Product Highlights

  • Two machines on one compressor: you change the tank and valve to switch between aerosol and foam. This means less equipment to buy, carry and maintain.
  • Several ways to apply with the aerosol unit: you can adjust from heavy mist to ULV fog, and you can also apply liquid only for crack and crevice work or air only for flushing. That covers wall void penetration, crack and crevice and localised fogging with one gun.
  • Built to be serviced: both units have stainless steel tanks, and the gun is brass and stainless steel. All units can be repaired in the field, so you don't need to send the unit away for service.

Target pests

This is application equipment, so the pests you can target depend on the registered product you load. Always confirm that the chemical label covers the pest and the application method. Typical uses include:

  • Termites (foaming wall voids)
  • Bed bugs
  • General pests in commercial kitchens and other commercial sites

Where to use

Approved use situations are set by the label of the chemical being applied. The equipment suits these settings:

  • Commercial kitchens and food-handling areas, where the chemical label permits
  • Wall voids in residential and commercial buildings
  • Cracks and crevices
  • Localised spaces where fogging is permitted

Application

Follow the chemical label for rates, dilution and approved application methods. Follow the manufacturer's manual for how to operate the equipment.

  • Foaming: fill the tank with chemical, water and foaming agent, turn on the compressor and apply. The self-regulating compressor keeps the tank at operating pressure, so foam output stays consistent without adjustment.
  • Foamer equipment: 3.8 L stainless steel tank, 2.1 m hose and a foaming tip. Other tips are available, including a straight metal tip and a flexible drain tip.
  • Aerosol: 3.8 L stainless steel tank, which lifts out of the case for cleaning and filling. Brass and stainless steel gun with a 45 cm (18 inch) extension, plus a 3 m recoiling hose.
  • Aerosol output: adjust the liquid pressure to get anything from a heavy mist to a ULV fog. You can also run liquid only for crack and crevice work or air only for flushing.
  • Portability: either unit can be removed from the case and disconnected from mains power to do spot treatments.
  • Changeover: swap the tank and valve on the shared compressor to move between aerosol and foam work.

Safety

Wear the PPE and follow the safety directions on the label of the chemical being applied. This unit runs on mains power, so follow the manufacturer's manual for safe electrical operation.

FAQ

  • Can I use any insecticide in this unit? Only products whose label allows the application method you're using, such as ULV/aerosol, fogging, foam or crack and crevice. The equipment does not extend what a product is registered for, so check the label before you fill the tank.
  • Is this the standard or commercial version, and what's the difference? This is the standard 220V unit with a 45 cm (18 inch) extension. The commercial version has a fan-cooled compressor and a 4.5 m hose instead of the standard 3 m recoiling hose.
  • Do I need mains power on site? The compressor needs power to run and to pressurise the tank. Either unit can be removed from the case and power source for short spot treatments. Both units are field repairable, so routine servicing doesn't mean sending the unit away.

Pack Size

Supplied as 1 combo unit: Portable Aerosol System and Versafoamer, 220V, standard, with 45 cm (18 inch) extension.

How to order: use Garrards product code BG/16600218.