ULV/Fog Formulations

VECTORFORCE THERMAL FOGGING & ULV INSECTICIDE CONCENTRATE 5L

Active ingredient25 g/L cypermethrin. The solvent is 862 g/L liquid hydrocarbon.

Code VECT/F/5

Downloads

Product details

Formulation

An oil-based ultra low volume (ULV) insecticide concentrate for thermal fogging and ULV use. Cypermethrin is a synthetic pyrethroid.

  • Insecticide group: Group 3A
  • Poisons schedule: Schedule 5 (S5) under the SUSMP
  • Signal heading: CAUTION
  • APVMA Approval No. 65430/50905

Overview

Vectorforce Thermal Fogging & ULV Insecticide Concentrate is a 25 g/L cypermethrin concentrate made by Sherwood Chemicals Australasia. It is used for the knockdown control of adult mosquitoes, biting midges, flies and cockroaches. Pest Management Professionals can use it indoors and outdoors.

It is designed for fast treatment of large spaces and open areas. Typical jobs include mosquito and biting midge programs, refuse tips, sports grounds, picnic and recreation areas, reserves, warehouses, factories, commercial kitchens and homes. Fog or ULV droplets spread through the air and settle on the surfaces where pests rest, so you can treat whole volumes and harbourages that a coarse spray would miss.

It is a knockdown product for adult insects only. Apply it when pest numbers are high, when there is a disease risk, or as part of a planned pest management program. Repeat treatments as conditions require.

Product Highlights

  • One concentrate works in three kinds of equipment: thermal foggers, cold aerosol ULV generators, and hand-held or knapsack sprayers. You can use the equipment you already own and suits the site, without stocking separate products.
  • One pack covers indoor and outdoor work. It is approved for warehouses, factories, kitchens, industrial buildings and homes, and for refuse tips, sports grounds, reserves and vector control programs. That suits contractors who move between commercial and public health jobs.
  • Flexible mixing, and no withholding period when used as directed. Outdoors you can apply it neat or diluted with an oil-based diluent such as DC Tron, or with kerosene, to match your equipment's output. For biting midges and all indoor work it must be diluted.

Target pests

Adults only.

  • Mosquitoes
  • Biting midges
  • Flies
  • Cockroaches

Where to use

  • Warehouses
  • Factories
  • Kitchens
  • Industrial buildings
  • Domestic residences
  • Refuse tips
  • Picnic areas
  • Sports grounds and recreation areas
  • Reserves
  • Vector control and biting midge programs
  • Public service areas, agricultural buildings, commercial and industrial areas, and breeding areas, as per the Directions for Use table

Application

Apply evenly with calibrated ground-based or hand application equipment. Spray into the air or onto surfaces where the target pests shelter. Treat while pests are active. Check the label for rates and for when to use the higher rate.

  • Equipment: thermal foggers, cold aerosol ULV generators, and hand-held or knapsack sprayers
  • Diluent: a suitable oil (e.g. DC Tron) or kerosene, mixed to suit your equipment's output rate
  • Indoors: always dilute in an oil-based diluent
  • Outdoors: apply neat or diluted. For biting midges it must be diluted, not applied neat
  • Mix fresh spray each time. Do not store diluted product
  • Do not spray over water intended for human consumption, or over or right next to any water body or watercourse
  • Remove or cover fish tanks and ponds before treatment
  • Dangerous to bees: do not spray plants in flower while bees are foraging. Treat at night or early morning

Safety

Signal heading: CAUTION. Poisons schedule: S5. Harmful if inhaled. May irritate the eyes and skin. Contact with facial skin may cause temporary numbness.

  • PPE when using: cotton overalls buttoned to the neck and wrist, washable hat, elbow-length PVC gloves, face shield or goggles, and a half facepiece respirator
  • Re-entry: do not enter while fog is still present. If you must enter earlier, wear cotton overalls, a washable hat, elbow-length PVC gloves and a respirator
  • Enclosed buildings: wait for the fog to clear, ventilate thoroughly, and clean thoroughly before food processing or serving resumes
  • Do not let spray contact food, food preparation surfaces or utensils, and do not spray directly on people
  • Dangerous to fish, aquatic invertebrates and bees
  • Store in the closed original container in a cool, well-ventilated place, out of prolonged direct sunlight
  • First aid: contact a doctor or the Poisons Information Centre on 13 11 26

FAQ

  • Can I dilute Vectorforce with water? No. Mix it with a suitable oil-based diluent such as DC Tron, or with kerosene, following your equipment maker's guidance on output rates. Outdoors it can also be applied neat, except for biting midges, which require a diluted mix.
  • Can I use it in commercial kitchens and food areas? Yes, kitchens are an approved use. Keep spray off food, food preparation surfaces and utensils. Wait for the fog to clear, ventilate, and clean thoroughly before food handling resumes. No withholding period is required when it is used as directed.
  • Will it control mosquito larvae or give long-term protection? No. It is registered for knockdown of adult insects only, so breeding sites need a separately registered larval control product. It is a Group 3A insecticide, and repeated use of Group 3A products can select for resistant populations. Rotate with other mode-of-action groups as part of a resistance management plan.

Pack Size

5 L

  • How to order: Garrards product code VECT/F/5