Garrards is an authorised dealer for Bosch Blue tools – the professional range, designed for trade use rather than the domestic green line. The tools below were the most commonly sold through Garrards branches, and Garrards also stocks Bosch drill bits.

Why the tool matters on a termite job
Slab and path drilling on an Australian perimeter treatment is high-volume, repetitive work in concrete, often in a confined subfloor or against a wall where the tool has to be handled one-handed. Impact energy, weight and toolholder type decide how long the job takes and how the technician’s shoulders feel at the end of the week – which is why the specifications below are worth reading rather than skipping.
Rotary hammers
GBH-4 Premium

- Rated power input 900 W
- Impact energy 0 to 5 J; impact rate at rated speed 0 to 3,600 bpm
- Rated speed 0 to 760 rpm
- Weight without cable 4.7 kg
- Toolholder SDS-plus
- Drilling diameter in concrete 6 to 32 mm; maximum in masonry 90 mm, steel 13 mm, wood 32 mm
GBH-36VF-Li

- Rated power input 600 W
- Impact energy 0 to 3 J; impact rate at rated speed 0 to 4,260 bpm
- Rated speed 0 to 960 rpm
- Weight including battery 4.5 kg
- Toolholder SDS-plus
- Drilling diameter in concrete with hammer drill bits 4 to 26 mm; maximum in steel 13 mm, wood 30 mm
GBH-36V-Li

- Rated power input 430 W
- Impact energy 0 to 1.8 J; impact rate at rated speed 0 to 4,850 bpm
- Rated speed 0 to 1,500 rpm
- Weight including battery 2.9 kg
- Toolholder SDS-plus
- Drilling diameter in concrete with hammer drill bits 4 to 18 mm; maximum in steel 13 mm, wood 30 mm
Multi-tool and drill driver
GOP-250CE

- Rated power 250 W
- No-load stroke rate 8,000 to 20,000 spm
- Oscillation 1.4 degrees left and right
- Weight 1.3 kg
GSR-36V-Li

- Voltage 36 V; battery capacity 2.6 Ah; charging time approximately 45 minutes
- Weight including battery 3.0 kg
- No-load speed 0 to 400 rpm (1st gear) / 0 to 1,400 rpm (2nd gear)
- Torque hard/soft 80 / 40 Nm; 25 + 1 torque settings
- Maximum drilling diameter in wood 50 mm, steel 16 mm; chuck jaw width 1.5 to 13 mm
Safety and compliance
Concrete drilling generates respirable crystalline silica dust. Australian workplace exposure limits for respirable crystalline silica have been tightened, and on-tool dust extraction, water suppression or appropriate respiratory protection is expected on this kind of work – check current Safe Work Australia guidance and your own SWMS. Electrical tools used on site must be tested and tagged in accordance with the applicable state requirements.
Available from Garrards
If you need a tool that is not listed here, contact your local branch for assistance.
