A blocked spray nozzle costs time on site and puts an uneven, off-rate application on your client’s property. The rega Nozzle Cleaner with O-Ring Pick is a pocket-sized spray nozzle cleaner made for pest managers, so a clogged nozzle can be cleared in seconds and put straight back to work.

What it is
The rega Nozzle Cleaner is a fold-out tool in a lightweight, durable aluminium case. It carries a set of stainless steel nozzle cleaners in graduated sizes plus a dedicated O-ring pick. It is small enough to live in a pocket, on a belt or in the sprayer’s tool pouch, so it is on hand whenever a nozzle starts to streak or drip.

Key features
- Lightweight, compact aluminium case that stands up to daily use in a vehicle or spray kit
- A range of stainless steel nozzle cleaners so you can start small and step up only as far as the orifice needs
- Integrated O-ring pick for removing O-rings from lances, wands and nozzle caps without gouging the seat
- Safe for use with most nozzle types
- Extends nozzle life instead of sending clogged nozzles to the bin
How to use it
- Open the tool and select the smallest nozzle cleaner.
- Thread the cleaner through the spray nozzle orifice to push out the debris.
- If the blockage does not clear, move up to the next size cleaner and repeat.
- Rinse the nozzle, refit it and test the spray pattern before resuming the job.
- Use the O-ring pick to lift worn or damaged O-rings from the sprayer so they can be replaced.
Start with the smallest cleaner and work up gradually. Forcing an oversized cleaner or a wire through a nozzle can enlarge the orifice, which changes the flow rate and spray pattern and means the nozzle no longer applies the labelled rate.
Why nozzle condition matters
Every pest management label in Australia specifies an application rate, and your sprayer only delivers that rate if the nozzle is clean and within its rated flow. Partially blocked nozzles under-dose part of the treated surface, leaving gaps in a termite trench or a cockroach harbourage treatment; worn nozzles over-dose and waste product. A quick check with the rega Nozzle Cleaner, combined with regular calibration of your sprayer, keeps applications accurate and helps you meet your obligations under the label and state licensing requirements.
Sprayer maintenance tips
- Use a nozzle strainer and keep it clean; most blockages come from debris or dried product upstream of the nozzle.
- Triple-rinse the tank and flush lines with clean water at the end of each day so residues do not dry inside the nozzle.
- Inspect O-rings on the lance, trigger and nozzle cap when you clean the nozzle, and replace any that are flattened, cracked or swollen.
- Calibrate the sprayer whenever a nozzle is changed and at regular intervals as part of your quality system.
- Wear gloves and eye protection when servicing nozzles that have been in contact with pesticide.
Available from Garrards
The rega Nozzle Cleaner with O-Ring Pick is available from Garrards branches along with rega sprayers, replacement nozzles, O-rings and spare parts. Contact your branch for pricing and availability.
Contact your local Garrards branch
Frequently asked questions
Will the rega Nozzle Cleaner damage my nozzles?
It is safe for use with most nozzles when you start with the smallest cleaner and only step up in size as needed. Avoid forcing an oversized cleaner through the orifice.
What is the O-ring pick for?
It lifts O-rings out of lances, wands and nozzle caps on spraying equipment so worn seals can be replaced without damaging the seat.
Does Garrards stock replacement nozzles and O-rings?
Yes. Garrards branches carry rega sprayers, nozzles, O-rings and spare parts. Contact your branch for the parts to suit your equipment.
