EZ Meazur is an adhesive drill spacing tape printed with marks at regular intervals to show exactly where to drill when injecting a chemical termiticide through concrete slabs, paths and paving. Stick it down, drill on the marks and peel it off: no chalk lines, no tape measure, and no marks lost under drilling dust.

What it is
The tape is supplied in 100 metre rolls in two versions, marked at 200 mm intervals or 300 mm intervals. The spacing you need depends on the termiticide being applied: labels for liquid termiticides specify a maximum drill-hole spacing for slab and perimeter injection, and the tape lets you match that spacing consistently along the whole run.

Key features and benefits
- Pre-marked at 200 mm or 300 mm to suit the termiticide label.
- Marks stay visible under drilling dust, unlike chalk lines.
- Lets you check that the line is straight before you start drilling.
- Can be laid out by a labourer and drilled with minimal supervision, freeing the licensed technician for the application itself.
- Consistent hole spacing on every job supports label compliance and a neater finished result for the client.
- Supplied in 100 m rolls.
How to use it
- Confirm the required hole spacing from the termiticide label.
- Clean loose dirt from the slab edge or path so the tape adheres.
- Run the tape along the treatment line, keeping the marks the specified distance from the wall or slab edge.
- Check the run is straight and continuous around corners and obstructions.
- Drill on each mark, inject the termiticide as per label, then remove the tape and plug the holes.

Where it fits in Australian termite work
Chemical soil treatments to slab-on-ground homes and paved areas are a large part of subterranean termite management in Australia, and the drilling stage is where most of the labour and most of the errors occur. Uneven spacing can leave gaps in the treated zone, while over-drilling wastes time and leaves unsightly plugs. A consistent, visible spacing guide makes the work faster, tidier and easier to document in the treatment report and certificate.
Safety and compliance
- Termiticide application must follow the APVMA-registered label, including drill-hole spacing and depth, and be carried out by a licensed pest management technician.
- Wear eye protection, hearing protection and a dust mask when drilling concrete; consider silica dust controls under work health and safety requirements.
- Locate services (water, gas, electrical) before drilling.
Downloads
Available from Garrards
EZ Meazur tape in 200 mm and 300 mm spacings is available from Garrards branches across Australia, alongside termiticides and injection equipment.
Contact your local Garrards branch
Frequently asked questions
Which spacing should I choose?
Match the tape to the maximum drill-hole spacing stated on the termiticide label you are applying. EZ Meazur is available in 200 mm and 300 mm versions.
How long is a roll?
Each roll is 100 metres.
Does it replace a chalk line?
Yes. The tape adheres to the surface and its marks remain visible under drilling dust, and you can check the line is straight before drilling.
