Projahn drill bits are now distributed in Australia by Garrards, and the first product we put through its paces was the Projahn 4×4 Zentro+ SDS-plus hammer drill bit. We tested it against the bit our customers buy most to answer a simple question: which one bores the better hole in concrete?

Why drill bit quality matters to termite technicians
A chemical termite barrier under a slab-on-ground home means drilling dozens, sometimes hundreds, of holes through concrete paths, patios and slab edges in a single day. A dull or cheap bit takes longer per hole, puts extra load on the rotary hammer and can overheat and snap. The finished hole also matters: a clean, round hole seals properly with a concrete plug, while a chipped, oversized hole looks unprofessional and is harder to make good.

What makes the Zentro+ different
- Four-cutter (4×4) carbide head instead of the conventional two-cutter tip.
- Centring point for accurate hole placement with minimal wander.
- Four flutes with matching channels to carry dust and debris away from the cutting face, which keeps the bit cooler and drilling faster.
- Less vibration and less cracking at the hole edge.
- Because each cutter does less work, the manufacturer rates the bit as up to five times more durable than a typical two-cutter concrete bit.
- Standard SDS-plus shank, so it fits any SDS-plus rotary hammer.
The Garrards test
- We first drilled a series of consecutive holes with a leading-brand SDS-plus bit with a standard dual cutting tip and photographed the best-looking hole of the batch.
- We then drilled with the Projahn 4×4 Zentro+ under the same conditions. During the test the Projahn bit struck steel reinforcement three times.
- Even after the reinforcing hits, the Zentro+ continued to produce a precise, smooth hole with noticeably less chipping around the edge.
The photographs below show the results. The cleaner hole from the Projahn bit pairs well with Rega concrete seals, giving a neat, professional finish on paths and driveways after a termite treatment.


Getting the most from your bits
- Let the hammer do the work; excessive feed pressure blunts cutters and stalls the tool.
- Withdraw the bit periodically on deep holes to clear dust.
- Match bit diameter to the plug or seal you intend to fit.
- Retire bits when the cutters are visibly rounded; a worn bit costs more in time than a new one.
Safety
Drilling concrete generates respirable crystalline silica. Use dust extraction or water suppression where practical, wear a fitted P2 respirator, safety glasses and hearing protection, and locate underground services before drilling paths and driveways.
Available from Garrards
As the authorised Australian distributor for Projahn, Garrards can offer German-engineered bits at trade-friendly prices. Contact your local branch for sizes, pricing and availability.
Contact your local Garrards branch
Frequently asked questions
Will Projahn Zentro+ bits fit my rotary hammer?
The Zentro+ bits tested here have a standard SDS-plus shank, so they fit any SDS-plus rotary hammer, including the Bosch Blue GBH range sold by Garrards.
Can the Zentro+ drill through reinforcing steel?
Hammer drill bits are designed for concrete and masonry, not steel. In the Garrards test the bit tolerated three contacts with reinforcement and kept drilling clean holes, but repeated drilling into steel will shorten the life of any bit.
