Kordon

KORDON TMB 1.2 X 50M

Active ingredient5 g/kg deltamethrin, equivalent to 2 g/m² deltamethrin.

Code KORD/1.2/50

Downloads

Product details

Formulation

Deltamethrin (a pyrethroid) is held in a flexible sheet. Polyester webbing carries the deltamethrin and is sealed between two UV-stabilised, low-density polyethylene sheets. The lower sheet is black.

Poisons schedule: exempt from scheduling under the SUSMP.

Overview

Kordon TMB (Termite and Moisture Barrier) is a termite barrier sheet with deltamethrin built in. It is installed during construction to stop subterranean termites getting into a building unseen. It is an APVMA-registered product (approval no. 60759) for protecting buildings and structures in line with AS 3660 Termite Management.

When laid under a concrete slab-on-ground, the same sheet also meets the water vapour barrier requirements of AS 2870-1996. One membrane does both jobs: it is a full under-slab termite barrier and a moisture vapour barrier.

Deltamethrin repels termites, so they avoid the sheet and try to go around it. To get around it they have to build mud tubes, which show up during regular inspections. This gives Pest Management Professionals the chance to find and treat the colony before termites get in unseen.

Product Highlights

  • One sheet, two compliance jobs: a termite barrier to AS 3660 and, under slab-on-ground, a water vapour barrier to AS 2870-1996. This means one less membrane to buy, lay and tape under the slab.
  • The chemical is sealed inside the sheet, so nothing is sprayed into the soil. Testing shows the sheet gives off no breathable dust and no volatile organic compounds (VOCs), so it meets the requirements for building products used in low-allergen housing. Deltamethrin is spread evenly at 2 g/m² across the whole sheet.
  • It is built to last on site and in service. The membrane is UV-stabilised, and testing showed no significant loss of deltamethrin after at least 3 months exposed on a concrete slab. The label states it can keep termites from getting in unseen for at least 20 years. The Kordon Termite System holds CodeMark certificate CM40380.

Target pests

  • Subterranean termites

Where to use

Approved in all states except Tasmania.

  • New building work, extensions and renovations
  • Retaining walls and other construction work that needs termite protection or management
  • Full under-slab system (termite and vapour barrier membrane) under concrete slab-on-ground
  • Perimeter barrier for all construction types, including in-fill slabs and slab-edge rebates. This is a partial barrier only and must be used with other approved termite barrier systems under AS 3660.1.
  • Service penetrations, using Kordon collars or patches cut from Kordon sheet

Application

Installation must follow the label, the Kordon Installation Manual and the current AS 3660.1 and Building Code of Australia. These are the key points at label level:

  • Before installing: inspect the site. Get rid of any active subterranean termite nests within the property boundary up to 50 m from the new building work, dig out stumps, logs and roots from the building footprint, and clear away timber off-cuts and building rubbish.
  • Two essential design rules: lay the lower (black) sheet facing the direction termites are expected to come from, and make sure the sheet is squeezed between two building elements.
  • Under-slab: lay on top of the bedding sand after footings and plumbing are finished and before the reinforcing steel goes down. Overlap joins and tape them with duct tape.
  • Every slab penetration must be protected, either with pre-made Kordon collars fixed with zip ties and duct tape, or by hand using Kordon patches, a Kordon collar strip, duct tape and cable ties.
  • Perimeter: fix with clouts or concrete nails plus a construction-grade adhesive or bonding agent. Leave enough ground clearance to inspect for termites bridging the barrier.
  • Equipment: duct tape, cable or zip ties, clouts or concrete nails, construction-grade adhesive and a cutting tool. The sheet can be cut and joined to fit complex designs.
  • Protect the sheet from damage. Make sure other trades on site know it is there until the building is finished.
  • Fix a durable notice to the building as the Building Code of Australia requires.

Safety

Signal heading: READ SAFETY DIRECTIONS BEFORE USE. Poisons schedule: exempt.

  • Do not touch or rub your eyes, nose or mouth with your hands. Contact with facial skin may cause temporary numbness. Wash hands after use.
  • PPE: the manufacturer says no special protective clothing is needed. The SDS lists nitrile gloves for hand protection.
  • Deltamethrin is dangerous to fish. Do not contaminate ponds, waterways or drains.
  • Storage: keep in the original packaging in a cool, well-ventilated place, out of prolonged direct sunlight and out of reach of children.
  • Disposal: do not burn packaging or unused product. Either place off-cuts on top of the moisture barrier before the concrete pour, or seal them in a Kordon delivery bag and take them to an approved waste facility.
  • First aid: if poisoning occurs, contact a doctor or the Poisons Information Centre on 13 11 26.

FAQ

  • Do I still need a separate vapour barrier under the slab? No. When used with a concrete slab-on-ground, Kordon TMB meets the water vapour barrier requirements of AS 2870-1996, so it serves as both the termite barrier and the moisture vapour barrier.
  • Can Kordon be used as a perimeter barrier on its own? No. A perimeter installation is only a partial barrier. To comply with building regulations it must be combined with other approved systems under AS 3660.1, such as a slab poured and cured to AS 2870. Like any barrier, Kordon stops termites getting in unseen but does not end the need for inspections. Inspect at least once a year to check termites have not bridged the barrier.
  • Who can install it, and where? Users must complete Kordon Accreditation and Training and be assessed as competent in installing physical termite barriers. Installation by Envu-trained and approved installers is backed by the Envu Kordon Warranty. The label approves use in all states except Tasmania.

Pack Size

One roll, 1200 mm wide x 50 m long, covering 60 m².

How to order: quote product code KORD/1.2/50.