BASF

SECLIRA WSG INSECTICIDE *200G*

Active ingredient400 g/kg dinotefuran

Code SECLIRA

Downloads

Product details

Formulation

  • Formulation type: water soluble granule (WSG). You mix it with water and apply it as a residual surface spray
  • Poison group: Group 4A insecticide (neonicotinoid)
  • Physical form: white, free-flowing fine granules with no odour
  • APVMA Approval No. 83011/118582

Overview

Seclira WSG Insecticide from BASF is a residual, broad-spectrum surface spray for Pest Management Professionals. It controls ants, cockroaches, spiders, flies, mosquitoes, wasps, fleas, bed bugs, stored product pests and other crawling insects. It is registered by the APVMA for use indoors and on external surfaces of domestic, commercial, industrial and public buildings.

Dinotefuran is non-repellent. Pests don't avoid treated surfaces, and the spray doesn't flush them out of cracks and crevices. This matters in occupied sites such as kitchens, hotels and hospitals, where flushing causes callbacks and visible pest activity. Because the spray is non-repellent, it also works alongside gel and liquid baits within an integrated pest management (IPM) program.

It is not a synthetic pyrethroid, so you can use it on pest populations that are resistant to synthetic pyrethroids. The granules dissolve clear in water. The spray is formulated not to stain or damage most building surfaces that water alone doesn't stain or damage.

Product Highlights

  • Non-repellent and non-flushing: pests keep walking over treated surfaces and stay in place during treatment. The spray doesn't stop pests feeding on gel baits such as Goliath Cockroach Gel, Amdro Cockroach Bait and Goliath Liquid Ant Bait, so you can run spray and bait programs together. BASF says the formulation includes its Genuine Transfer Effect technology.
  • Not a synthetic pyrethroid: as a Group 4A insecticide, it controls pest populations resistant to synthetic pyrethroids and gives you a different mode of action to rotate with.
  • Dissolves clear, odourless and non-staining: the solution stays evenly mixed in the tank, so application is consistent. It won't stain surfaces that water alone doesn't stain, which suits homes, hotels, offices, hospitals and food premises where residue or odour would be a complaint.

Target pests

  • Ants
  • Cockroaches
  • Mosquitoes
  • Flies, including house flies (Musca domestica)
  • Wasps
  • Fleas
  • Stored product pests, including beetle pests and adult moths (non-porous surfaces only)
  • Bed bugs
  • Spiders
  • Crawling insects, including crickets, millipedes, pillbugs and springtails

Where to use

Seclira WSG is approved for use in domestic, commercial, industrial and public buildings and facilities, and in the external areas associated with them. Approved sites include, but aren't limited to:

  • Food processing establishments, shops, factories and storerooms
  • Farm buildings
  • Hotels and backpacker accommodation
  • Ships, trains and aeroplanes
  • Offices, schools, hospitals and barracks
  • Private houses
  • External surfaces and perimeters, including walls, eaves, weep holes, voids, awnings, fences, landscape materials and soil next to structures
  • Restrictions: for stored product pests, use on non-porous surfaces only. Don't apply to food, food utensils or food preparation areas. Don't spray livestock or their food, water, litter, feed bins or any surfaces stock can reach.

Application

Apply as a diluted residual surface spray. Rates vary by pest and surface type (porous or non-porous). Always follow the rates on the product label.

  • Equipment: handheld sprayer, knapsack sprayer or truck-mounted tank sprayer
  • Mixing: fill the spray tank ¼ to ½ full of water, add the product, mix with mechanical or hydraulic agitation, then add the rest of the water
  • Calibrate your equipment for the area to be treated, and don't spray past the point of run-off
  • Use a coarse spray on non-porous surfaces, a fine mist in wall voids and enclosed cavities, and a pin stream for cracks and crevices
  • Focus on harbourages, cracks and crevices, entry points, nests, trails and resting surfaces
  • Apply to clean surfaces where possible. Dirt, oil and grease reduce performance and can cause staining from run-off.
  • Test a small concealed area first, especially on carpets. Let treated carpets dry before people walk on them again.
  • For spiders and wasps, leave webbing or nests in place for a few days after treatment so the product works fully
  • Surface treatment only: don't use foggers or other devices that create an aerosol
  • Don't spray outdoors if heavy rain is expected within 48 hours or the area is about to be irrigated

Safety

Signal heading: CAUTION (the Schedule 5 signal heading under the SUSMP).

  • PPE when opening the container and preparing the spray: cotton overalls buttoned to the neck and wrist (or equivalent), elbow-length chemical-resistant gloves and goggles
  • Will irritate the eyes. Avoid contact with eyes and avoid breathing in the dust.
  • Re-entry: keep out of treated areas until the spray has dried, unless wearing cotton overalls and chemical-resistant gloves
  • Very toxic to aquatic life with long-lasting effects. Cover fish tanks, and don't contaminate streams, rivers or watercourses.
  • Don't spray people, clothing, exposed food, moving machinery parts, electric motors or switchgear
  • Store in the closed original container in a cool, well-ventilated area, out of prolonged direct sunlight
  • First aid: Poisons Information Centre 13 11 26

FAQ

  • Can I use Seclira WSG with baits? Yes. It is non-repellent and doesn't stop pests feeding on gel baits. For indoor ant problems, the label recommends an external perimeter spray plus a registered indoor bait such as Goliath Liquid Ant Bait. For cockroaches where spraying isn't suitable, use a registered gel instead.
  • Will it stain or leave an odour in sensitive sites? The granules dissolve clear and the product is odourless. It is formulated not to stain or damage most building surfaces that water alone doesn't affect. Run-off on dirty or greasy surfaces can still stain, so test a concealed area first. On carpets, use the lower water volume where you can.
  • Is it suitable for pyrethroid-resistant pests, and what are its limits? It is not a synthetic pyrethroid, so it can control populations resistant to synthetic pyrethroids. As a Group 4A insecticide, rotate it with other modes of action to manage resistance. For flies and mosquitoes, it only controls insects that land on treated surfaces, so insects flying in from untreated areas may still be seen. Stored product pest treatments are limited to non-porous surfaces, and fogging isn't permitted.

Pack Size

  • Pack size: 200 g
  • How to order: Garrards product code SECLIRA