Agenda Termite Baiting System: On-Ground and In-Ground

The Agenda Termite Baiting System is built around one observation: termites are found in timber above ground, because that is where the scouts go looking. Agenda therefore puts stations on the ground as well as in it. The system has three parts – On-Ground bait stations, In-Ground bait stations, and Agenda Termite Bait in a foil pouch that works in either station type and directly in active workings above ground.

Agenda Termite Baiting System
The Agenda Termite Baiting System.

Where it fits

Agenda was developed to extend and complement the existing termite portfolio alongside Premise 200SC Termiticide and Kordon Termite Barrier, with an integrated termite management program recommended for best results.

On-Ground stations

Agenda On-Ground termite bait station
Agenda On-Ground station.

Trials in the USA in the 1970s indicated that stations located on or above the ground are found much sooner than stations placed in the ground. Australian termite infestations point the same way: all timber damaged in service is above ground, because termite scouts have come up from the soil to find it. Installing stations containing timber on the ground surface intercepts termites where they are already foraging.

  • No digging and no concrete drilling
  • Can be moved easily if required
  • Timber decay almost non-existent
  • Larger timber pieces, so more termites can be aggregated
  • Two timber types in each station: Tasmanian oak and radiata pine
  • Concrete-grey, UV-stable plastic to suit the harsh Australian environment and blend with most surroundings

In-Ground stations

Agenda In-Ground termite bait station
Agenda In-Ground station.

In-Ground stations have been the accepted standard for termite aggregation for 15 years and more, and suit lawns and any other appropriate area.

  • Station diameter 150 mm, depth 160 mm – a shorter depth for easier installation, using a standard 150 mm auger
  • An aerial can be used to find the station or to assist in opening it
  • Larger timber sizes increase the time active termites feed at the station and allow more termites to be aggregated
  • Each station is loaded with two timber types: 2 x Tasmanian oak and 2 x radiata pine, timber volume 558 cm3

Above-ground baiting in structures

Agenda above-ground foil pouch bait application
Agenda foil pouch bait applied above ground.

Applications include fences, gates, posts, retaining walls, sheds and houses. The method from the original page:

  1. Once termite activity is discovered in timber, make a small 5 to 10 mm hole to access the workings with a small-bladed screwdriver or pocket knife, ensuring minimal disturbance.
  2. Prepare the bait as per instructions, remove the bottom label, align the opening in the foil pouch over the access hole and affix the pouch to the surface. Vertical surfaces may need tape, tacks, staples or small nails to assist adhesion. If the hole in the foil pack cannot be aligned with the hole in the workings, cut a small hole in the bait pouch to line up with the workings, place a small amount of bait into the hole in the workings to promote feeding, then attach the pouch.
  3. Optionally, a ‘Baiting in Progress’ lid can be used to cover the foil pouch, secured with tape, screws or tacks.
Agenda On-Ground station installation
Agenda On-Ground stations in place.

Safety and compliance

Agenda Termite Bait must be APVMA-registered and used strictly in accordance with the label. Termite management work in Australia is carried out to AS 3660, monitoring and baiting programs must be documented with the inspection interval agreed in writing, and a baiting program does not replace the annual timber pest inspection. Termite work is restricted to licensed pest management technicians under state and territory legislation. Always work from the current label and Safety Data Sheet.

Available from Garrards

Contact your nearest Garrards branch to confirm current availability and pricing.

Contact your local Garrards branch