Micro Emulsion

BIFLEX MIKRON 1L

Active ingredientBifenthrin 64 g/L: a synthetic pyrethroid (Group 3A) that acts on the sodium channels of the insect nervous system + Acetamiprid 53 g/L: a neonicotinoid (Group 4A) that acts on the acetylcholine receptors

Code BIF/MIK/1

Downloads

CategoriesMicro Emulsion

Product details

Formulation

Biflex Mikron is a microemulsion (ME) concentrate. You mix it with water and apply it as a residual surface spray or directly to target pests.

  • Formulation type: microemulsion (ME), diluted with water
  • Mode of action groups: Group 3A and Group 4A insecticide
  • Signal heading: POISON
  • Restricted Chemical Product: it may only be supplied to, or used by, an authorised person

Overview

Biflex Mikron is a dual-active residual insecticide for Pest Management Professionals. It controls crawling and flying urban pests inside and outside buildings, including ants, cockroaches, spiders, flies and mosquitoes. Applied as a surface spray as directed, it gives up to 3 months' control of listed pests.

It combines bifenthrin, the active ingredient in Biflex Aqua and Biflex Ultra, with acetamiprid, a neonicotinoid. FMC introduced acetamiprid to the Australian professional pest management market with this product. The two actives come from different chemical groups and attack the insect nervous system in different ways. You get both a fast knockdown and a residual barrier from one concentrate.

The microemulsion has a particle size 200 times smaller than suspension concentrate (SC) formulations and thousands of times smaller than micro-encapsulated products. Once mixed, the spray is completely clear, so it won't leave the cloudy residue that can lead to callbacks over marks on finished surfaces.

Product Highlights

  • Two modes of action in one product: bifenthrin (3A) and acetamiprid (4A) give contact knockdown plus residual control of up to 3 months on treated surfaces, without tank-mixing two products.
  • Clear, non-staining microemulsion: the mixed spray is clear and won't leave cloudy residues. It is safe on most surfaces where water alone can be safely applied. The fine particles spread evenly over treated surfaces, so insects are more likely to pick up an effective dose. They are also absorbed through the insect cuticle more readily.
  • Stays mixed and is non-repellent in trials: the product does not settle out in the tank, so the active stays evenly spread without constant agitation, and nozzle blockages are less of a concern. Australian trials commissioned by FMC found treated surfaces were not repellent to German cockroaches or foraging black ants. In laboratory tests, the insecticide was passed from treated insects to untreated ones in the nest.

Target pests

  • Cockroaches, including American and German cockroaches
  • Ants
  • Spiders
  • Flies
  • Mosquitoes
  • Biting midges
  • Fleas
  • Ticks
  • Paper nest wasps

Where to use

Biflex Mikron is registered for internal and external use in domestic, commercial, industrial and public buildings and structures.

  • Buildings including barracks, factories, farm buildings, schools, shops and storerooms
  • Transport equipment such as aircraft and boats
  • Porous and non-porous surfaces, including cement (painted, unpainted and rendered), ceramic tiles and painted plasterboard
  • Perimeter and banded treatments on soil or vegetation around and next to structures, including building foundations
  • Not for farm buildings where grain or crop produce is stored, mangroves or aquatic habitats

Application

Mix with water and apply as a coarse, low-pressure surface spray. Most conventional spray equipment can be used. The label sets the rates for each pest and situation.

  • Mixing: half fill the spray tank with water and shake Biflex Mikron before use. Add the measured dose, top up with the rest of the water, then close, shake and pump the sprayer to the correct pressure.
  • Surface sprays: target areas where pests hide, frequent and rest. On non-porous surfaces, don't spray past the point of run-off.
  • Porous surfaces: the label allows power spray equipment.
  • Crack and crevice treatment: use appropriate equipment as directed on the label.
  • Ants: treat trails and nests, and repeat as needed.
  • Perimeter treatments: spray a band of soil or vegetation 2–3 metres wide around the structure, and treat the foundation to about 1 metre high.
  • The label's higher rate is for high pest pressure or when you need rapid knockdown or maximum residual protection.
  • Do not use as a space spray, as a broadcast spray indoors or through thermal fogging equipment.
  • Do not apply outdoors if heavy rain or storms are forecast within 3 days, or to soils that are very wet or have just had heavy rain.
  • Resistance management: follow the label's Group 3A and 4A resistance warnings and rotate chemistry.

Safety

Signal heading: POISON. Keep out of reach of children. This is a Restricted Chemical Product, for supply to and use by authorised persons only. Read the label safety directions and the Safety Data Sheet before use.

  • PPE: when preparing and applying the spray, wear cotton overalls buttoned to the neck and wrist (or equivalent clothing)
  • May irritate the eyes. Avoid contact with eyes.
  • Wash hands after use. After each use, wash gloves and contaminated clothing.
  • Before treating, remove or cover all exposed food. Don't let spray contact food, food preparation surfaces or utensils.
  • Do not enter treated areas until the spray has dried.
  • Do not spray livestock, their feed, water, litter or surfaces they can reach.
  • Moderately toxic to bees, and acetamiprid has systemic action. Don't spray flowering plants that attract bees or let drift reach them.
  • Very toxic to aquatic life with long-lasting effects. Toxic to native mammals and birds.
  • SDS hazard statements: harmful if swallowed; suspected of causing cancer; causes damage to organs through prolonged or repeated exposure

FAQ

  • Will Biflex Mikron repel ants and cockroaches before they pick up a lethal dose? Not in FMC's trials. Independent Australian trials commissioned by FMC found German cockroaches and black ants walked over treated porous and non-porous surfaces and kept foraging normally. In laboratory tests, treated ants and cockroaches passed the insecticide on to untreated nestmates.
  • Will it stain or leave residue on finished surfaces? It is designed not to. The mixed spray is clear, leaves no cloudy residue and is safe on most surfaces where water alone can be safely applied. On non-porous surfaces, don't spray past the point of run-off.
  • Can I use it for termites, space spraying or food areas? No to the first two: termites are not on the label, and the label prohibits space spraying, thermal fogging and broadcast spraying indoors. In food handling areas, cover or remove all food first and keep spray off food, food preparation surfaces and utensils. Outdoors, don't apply if heavy rain is forecast within 3 days, and avoid flowering plants that attract bees.

Pack Size

Biflex Mikron is available in a 1 L pack.

  • Pack size: 1 L
  • How to order: Garrards product code BIF/MIK/1